Clutch problems.

Post your 650/600 questions here.

Clutch problems.

Postby tom555cwrs » Thu Apr 06, 2017 1:17 pm

Hi. I have a 1989 dr600 am having problems with the clutch. It was slipping slightly so i took it apart all the plate look ok and are in specification. I fitted new springs and one extra metal plate going by what i read somewhere. Put it all back together and the clutch wouldnt release even though it felt fine on the lever. Took apart again removed the extra plate. Same thing. Took apart again and added the plate again. And didnt do the centre nut up as tight. Clutch worked but was slipping like mad. What is the correct amount of plates metal and friction for the clutch. Also i dont have the wave washers fitted. Is the centre nut torque vital. As i dont have a clutch hold to be able to torque it. Just been using a small rattle gun. Any ideas. Thanks.
tom555cwrs
Virgin - be gentle
Virgin - be gentle
 
Posts: 1
Joined: Thu Apr 06, 2017 1:02 pm

Re: Clutch problems.

Postby DHC6 » Fri Apr 07, 2017 8:00 pm

http://www.dr-big-shop.de/600_MotorKupplung_1036.html

This is most of the time the problem, if this spacer sticks all goes up sh.. creek.

Good luck

R
User avatar
DHC6
Regular
Regular
 
Posts: 58
Joined: Sun Jan 15, 2017 10:30 am
Location: middle of France


Return to DR650/DR600

Who is online

Users browsing this forum: No registered users and 2 guests

cron

x