Few problems after reassembling...

Questions regarding the DR800

Re: Few problems after reassembling...

Postby O.R. » Sat Feb 10, 2018 6:22 pm

Yuza wrote:..maybe the oring in the slider guide? Ultrasonic cleaning might have moved it or damaged it...?

I hope you dropped the carbs in the ultrasonic cleaner disassembled :!:

Ultranic cleaning leads to a lot of fine rubbish. When carbs are "cleaned" without disassembly, a lot of dirt will be "trapped" behind the fuel/air jets.
In that case, your air jets could be clogged.

Yuza wrote:I am now thinking of the main needle, might be worn!

A worn (jet) needle can be identified by just looking at it.
User avatar
O.R.
Regular
Regular
 
Posts: 66
Joined: Fri Jan 20, 2017 8:51 pm
Location: the Netherlands

Re: Few problems after reassembling...

Postby Yuza » Mon Feb 12, 2018 12:33 pm

He did it, same mechanic whom I brought the bike to...
The needle didn’t look worn when he dismantled the carbs before cleaning, otherwise I would have replaced it.
I would bet my money (which I will need to spend soon to pay for the job so no bets...) on the slider guide o-ring.
At least it would be cheap....well, finger crossed
Yuza
Regular
Regular
 
Posts: 59
Joined: Mon Sep 25, 2017 5:42 pm

Previous

Return to DR800

Who is online

Users browsing this forum: No registered users and 1 guest

x